empty cell
Manual on Uniform Traffic Control Devices (MUTCD) arrows logo
Knowledge bar

2009 Edition Part 4 Figure 4E-4. Typical Pushbutton Locations (Sheet 2 of 2)

Full-size image of Figure 4E-4, Sheet 2

Figure 4E-4. Typical Pushbutton Locations (Sheet 2 of 2)

This figure contains eight examples of typical pushbutton locations on two sheets.

Sheet 2 shows four examples.

A legend shows a horizontal black arrow labeled "Downward Slope," a black disk with a short stem labeled "Pedestrian Pushbutton," a crosshatch area labeled "Detectable Warning (per ADAAG)," and a diagonally striped area labeled "Landing Area (per ADAAG)."

The following notes are included:

  1. This figure is not drawn to scale.
  2. These drawings are intended to describe the typical locations for pedestrian pushbutton installations. They are not intended to be a guide for the design of curb cut ramps.
  3. Figure 4E-3 shows the recommended area for pushbutton locations.

Each example shows a plan view of one corner of a 90-degree intersection of two streets, each with a sidewalk. On each section of street, two sets of parallel white lines denoting crosswalks are shown, one horizontal to the left of the corner, and one vertical below the corner. On the corner radius, two curb-cut ramps are shown, one aligned with the east-west crosswalk and one aligned with the north-south crosswalk.

The first example is labeled "E – Perpendicular Ramps with Crosswalks Close Together." It is shown with the corner denoted as a 30 ft corner radius and sidewalks as a dimension of 12 ft wide. The crosswalks are shown close to the corner. Each sidewalk ramp leading to a crosswalk is shown with a vertical black arrow centered on each ramp and pointing toward the street, denoting a downward slope. The pedestrian pushbutton symbol is shown to the outside of each ramp and close to the street. The half of each ramp farthest from the street is shown marked with diagonal stripes, denoting a landing. The pedestrian pushbutton symbol is shown on the outside of each ramp at the point where the landing ends and the downward slope begins. A narrow strip of the ramp at the street edge is marked with crosshatching, denoting an area of detectable warning.

The second example is labeled "F – Perpendicular Ramps with Sidewalk Set Back from Road with Crosswalks Far Apart." It is shown with the corner denoted as a 30 ft corner radius and sidewalks as a dimension of 5 ft wide. The crosswalks are shown slightly farther away from the corner. A green strip is shown between the sidewalk and street. Each sidewalk ramp leading to a crosswalk is shown with a vertical black arrow centered on each ramp and pointing toward the street, denoting a downward slope on the green strip. The half of each ramp farthest from the street is shown marked with diagonal stripes, denoting a landing. The pedestrian pushbutton symbol is shown on the outside of each ramp at the point where the landing ends and the downward slope begins. A narrow strip of the ramp at the street edge is marked with crosshatching, denoting an area of detectable warning.

The third example is labeled "G – Perpendicular Ramps with Sidewalk Set Back from Road with Crosswalks Close Together." It is shown with the corner denoted as a 30 ft corner radius and sidewalks as a dimension of 5 ft wide. The crosswalks are shown very close to the corner. A green strip is shown between the sidewalk and street. Each sidewalk ramp leading to a crosswalk is shown with a vertical black arrow centered on each ramp and pointing toward the street, denoting a downward slope on the green strip. The half of each ramp farthest from the street is shown marked with diagonal stripes, denoting a landing. The ramps are shown at right angles to each other with the landing areas overlapping. The pedestrian pushbutton symbol is shown on the outside of each ramp at the point where the landing ends and the downward slope begins. Near the street, a narrow strip of the ramp is marked with crosshatching, denoting an area of detectable warning, and a strip next to the street is shown marked with diagonal stripes, denoting a landing.

The fourth example is labeled "H – Perpendicular Ramps with Sidewalk Set Back from Road with Continuous Sidewalk Between Ramps." It is shown with the corner denoted as a 10 ft corner radius and sidewalks as a dimension of 5 ft wide. The crosswalks are shown close to the corner. A green strip is shown between the sidewalk and street, but sidewalk is shown between the ramps on the green strip. Each sidewalk ramp leading to a crosswalk is shown with a vertical black arrow centered on each ramp and pointing toward the street, denoting a downward slope on the green strip. The half of each ramp farthest from the street is shown marked with diagonal stripes, denoting a landing. The ramps are shown at right angles to each other with a portion of each landing area overlapping the other. The pedestrian pushbutton symbol is shown on the outside of each ramp at the point where the landing ends and the downward slope begins. A narrow strip of the ramp at the street edge is marked with crosshatching, denoting an area of detectable warning.

Back to: Sheet 1

Back to Chapter 4E